Skip to content
Lakewood, CO · Jefferson County

Lakewood Garage Coatings

Lakewood garages face a relentless set of challenges: road salt tracked in from Colfax and Alameda commutes, freeze-thaw cycles that crack bare concrete year over year, motor oil from weekend wrenching, and the general grime of an active Colorado household. Elevated Epoxy Co installs garage floor coatings across Lakewood and Jefferson County that stop all of that cold, look sharp for 15 or more years, and install in a single day for most residential two-car garages.

Polyaspartic flake garage floor coating in a Lakewood, CO home by Elevated Epoxy Co

Lakewood Garage Floor Coatings That Last

Our standard Lakewood garage system is a four-step build: 100 percent solids epoxy primer, broadcast vinyl flake at full saturation, polyaspartic topcoat, and a slip-resistant final pass. Total dry-film thickness runs 25 to 30 mils. The flake layer masks minor concrete imperfections and gives the floor visual depth, the polyaspartic topcoat handles hot tire contact and chemical exposure without peeling, and the slip-resistant texture keeps the surface safe when wet from snow tracked in off the driveway.

Lakewood concrete sees a lot. Many homes in Green Mountain and Applewood were built in the 1960s and 1970s, meaning the garage slabs are 50 or more years old with surface porosity, settled cracks, and old paint or sealer that needs to come off. We diamond-grind every floor with 30-grit metal-bond pads to expose clean aggregate, vacuum to HEPA spec, fill cracks and voids with polyurea joint filler, and only acid-etch where mechanical grinding can not reach. Bad surface prep is why coatings fail in two years. We document every prep step with photos and never skip it.

What to Expect from a Lakewood Garage Coating Job

Flake colors run from neutral grays and tans (the most common choice in Lakewood for resale neutrality) to bolder blends with blue, red, or copper accents. Solid color epoxy is available for a clean industrial look. Metallic epoxy with a polyaspartic topcoat is the high-end option for showpiece garages and converted workshop spaces. It runs about 35 to 40 percent more than a standard flake system and delivers a finish that looks nothing like typical garage floors.

10+Years In Business
LocalParker, CO
FreeQuotes
InsuredLicensed & Bonded

Lakewood Garage Coating Project Timeline

Most Lakewood single-bay garages install in one day. Two-car garages run one to one and a half days. Three-car or oversized garages take one and a half to two days. Drive-on time is 24 hours after final coat for foot traffic, 72 hours for vehicles. Colorado’s dry climate and Lakewood’s elevation accelerate cure compared to humid markets, but we still recommend the full 72 hours before moving vehicles back in.

Ready for Lakewood garage floor coatings?

Call us, send a message, or browse the gallery to see completed Lakewood projects.

Lakewood Garage Coatings FAQ

How much does a Lakewood garage floor coating cost?

A standard flake-and-polyaspartic two-car Lakewood garage runs $2,800 to $4,200 installed. Metallic epoxy adds 35 to 40 percent. Three-car garages scale linearly by square footage. Free quotes include on-site measurement so you get an accurate number before committing to anything.

Does epoxy hold up to Colorado winters in Lakewood?

Polyaspartic topcoats are rated for temperature swings well below zero. Cracks in the coating almost always come from concrete movement underneath, not coating failure. We fill pre-existing concrete cracks with flexible polyurea before applying the coating so movement does not telegraph through to the surface.

Will hot tires lift the coating?

Not with a commercial-grade polyaspartic topcoat. Big-box DIY kits frequently fail on hot tires because they use water-based formulations not designed for it. Every garage floor we install uses a solvent-based polyaspartic designed for daily vehicle traffic in Colorado conditions.

How soon can I drive on it after installation?

Foot traffic is clear at 24 hours. Vehicles need 72 hours. Lakewood’s altitude and low humidity speed up the cure compared to coastal climates, but we still hold the full 72 for vehicle re-entry to make sure the polyaspartic has fully cross-linked.

Do I need to move everything out before you start?

Yes. The garage needs to be clear for grinding and coating. Most homeowners stage contents in the driveway, a pod, or a storage unit for two days. We send a checklist a few days before install with exactly what needs to happen to prep the space.

Service Area: Lakewood, CO

We serve all of Lakewood, CO and surrounding Jefferson County neighborhoods including Green Mountain, Applewood, Bear Creek, Belmar, and beyond.